|
| ||||
) RC1902 Remote Control to operate manual mode, temperature, on/off and hold/unhold- for model S1902 and HP22. | |
) CB1902 Software based control board mounted at rear top of pellet stove - for model S1902 and HP-22. | |
) PB1902 This power board is located at the left side of the pellet stove behind the rear left panel - for model S1902 and HP-22. |
) FS1902 Replacement fuse for electronic circuit board. | |
) RC1902 Ribbon cable that connect the program board with the power board - for model S1902 and HP-22. | |
) EXM1902 Exhaust motor - complete - can be easily removed by undoing 4 wing nuts, located at the rear bottom of the stove - for model S1902 and HP-22. |
) COF1902 Squall cage design convection motor with a very quite operation is located at the center / rear of the fire box, can be removed very quickly, the speed is controlled by computer for maximum efficiency - for model S1902 and HP-22. | |
) AUM1902 A new and unique Auger motor design to give more reliability and strength with a very quite operation, located at rear of pellet stove just bellow hopper - for model S1902 and HP-22. | |
) MC1902 Motor capacitor which is clipped onto frame close to auger motor. Gives more stability and torque to auger motor - for model S1902 and HP-22. |
) IG1902 Igniter with cable and easy connector. Used to ignite the pellets to allow for automatic operation for model S1902 and HP-22. | |
) TC1902 Thermostat located on the exhaust motor housing to let the computer know that a fire has been established. Closes at 120F - for model S1902 and HP-22. | |
) TH1902 High limit thermostat located at the rear left side of body, lets the computer know that a too high of a temperature has been reached - for model S1902 and HP-22. |
) PS1902 Pressure switch located at rear left side where the power board is mounted, lets computer know that exhaust fan is working and that all doors are closed and the body is sealed - if any of these conditions do not exist the pressure switch will let computer know not to feed any pellets - for model S1902 and HP-22. | |
) RB1902 Decorative rear board which provides a barrier between hopper/components and burn area, located behind burn pot on back wall- for model S1902 and HP-22. | |
) SB1902 Decorative side boards which provides a barrier between hopper/components and burn area, come singly- for model S1902 and HP-22. |
